All vacuum cleaners require maintenance and the Henry is no exception.

The pre-motor filter consists of two components – foam and felt layers – and the post-motor filter is a single piece.. Here’s.how to clean the filters on a Shark vacuum.

Remove the pre-motor filter from the top of the dust cup..Tap off excess dirt into a bin.. Rinse the filter with cold water only.Do not use detergents or soap..

Remove the post-motor filter from the main body of the vacuum.. Again, rinse with cold water only until the water runs clear..Allow both filters at least 24 hours to fully dry before putting them back into the vacuum cleaner.. Be careful when cleaning the felt filters, as these are easy to damage.

Don’t worry if the filters are discoloured – this is completely normal.

Avoid scrubbing the filters as this can cause damage..There are many advantages to backpack vacs for commercial cleaning.

Backpack vacuums are more mobile than an upright vacuum cleaner.. Backpack vacuums often have long power cords to increase efficiency.There are also cordless models for extra freedom, although these have a limited battery run-time.. It’s easier to use a backpack vacuum when cleaning in tight locations, as you don’t need to push the entire vacuum body into the space..

Most backpack vacuums come with long wands for cleaning vents, blinds, and other above-floor locations.. Backpack vacs increase the productivity of cleaners..Most backpack vacuums are designed for commercial cleaning, so they are durable and long-lasting.. Backpack vacuums have improved ergonomics compared with upright vacuums, as the harness allows for a neutral spine (if properly fitted.)